Toyota Highlander Service Manual: Crankshaft position sensor (2AZ-FE)
REPLACEMENT
HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cover
2. REMOVE FRONT FENDER APRON SEAL RH
(a) Remove the clip, 2 bolts and apron seal.
3. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the sensor connector.
(b) Remove the bolt, clamp and sensor.
4. INSTALL CRANKSHAFT POSITION SENSOR
(a) Install the sensor and clamp with the bolt.
Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf) (b) Connect the sensor connector.
5. INSTALL FRONT FENDER APRON SEAL RH
(a) Install the clip, 2 bolts and apron seal.
6. INSTALL ENGINE UNDER COVER NO.1
(a) Install the 6 screws, 2 clips and under cover.
Camshaft position sensor (2AZ-FE)
REPLACEMENT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (see
page 03-2 ).
1. REMOVE AIR CLEANER ASSY (See page 14-24 )
2. REMOVE CAMSHAFT POSITION SENSOR
...
More about Toyota Highlander:
Heater & air conditioner
PREPARATION
SST
Recomended Tools
EQUIPMENT
...
