Up to 5 bluetooth® devices (phones [hfp] and audio players [avp]) can be registered.
If more than 1 bluetooth® device has been registered, select which device to connect to.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Supported profile icons will be displayed.
Supported profile icons for currently connected devices will illuminate.
Dimmed icons can be selected to connect to the function directly.
Auto connection
To turn auto connection mode on, set "bluetooth* power" to on.
When you register a phone, auto connection will be activated. Always set it to this mode and leave the bluetoothr phone in a place where a connection can be established.
When the audio system is turned to on, the system will search for a nearby cellular phone you have registered.
Next, the system automatically connects with the most recent of the phones connected to in the past. Then, the connection result is displayed.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Manual connection
When auto connection has failed or "bluetooth* power" is turned off, you must connect the bluetoothr device manually.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Connecting a bluetooth® audio player
Reconnecting a bluetooth® phone
If the system cannot connect due to poor signal strength, the system will automatically attempt to reconnect.
If the phone is turned off, the system will not attempt to reconnect. In this case, the connection must be made manually, or the phone must be reselected.
Speed sensor rear LH (4WD)
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. REMOVE DECK TRIM SIDE PANEL ASSY LH (SEE PAGE 76-21 )
2. REMOVE REAR WHEEL
3. REMOVE SPEED SENSOR REAR LH
(a) Disconnect the speed sensor connector.
NOTICE:
B ...