COMPONENTS
REPLACEMENT
HINT:
Installation is in the reverse order of removal.
1. PRECAUTION (SEE PAGE 60-1 )
2. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE PAGE 60-1 )
3. REMOVE FRONT BUMPER COVER (SEE PAGE 76-2 )
4. REMOVE RADIATOR GRILLE (SEE PAGE 76-2 )
5. REMOVE LH HEADLAMP ASSY (SEE PAGE 65-10 )
6. REMOVE AIRBAG SENSOR FRONT LH
(a) Disconnect the connector from the airbag sensor front LH.
(b) Remove the 2 bolts and the airbag sensor front LH.
7. INSTALL AIRBAG SENSOR FRONT LH
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
(c) Install the airbag sensor front LH with the 2 bolts.
Torque: 9.0 NVm (92 kgfVcm, 80 in.Vlbf)
NOTICE:
(d) Connect the connector to the airbag sensor front LH.
(e) Check that there is no looseness in the installation parts of the airbag sensor front LH.
8. INSTALL LH HEADLAMP ASSY (SEE PAGE 65-10 )
9. HEADLIGHT AIM ONLY (SEE PAGE 65-14 )
10. CONNECT BATTERY NEGATIVE TERMINAL
11. INSPECT SRS WARNING LIGHT (SEE PAGE 05-1207 )
Moon roof
Use the overhead switches to open and close the moon roof and
tilt it up and down.
Opening and closing
Opens the moon roof*
the moon roof stops slightly
before the fully open position to
reduce wind noise.
Press the switch again to fully
open the moon roof.
Closes the moon roof*
...