Toyota Highlander Service Manual: Adjustment

Toyota Highlander Service Manual / Heater & air conditioner / V (cooler compressor to crankshaft pulley) belt NO.1 / Adjustment

1. ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

(a) Loosen bolt A.

(b) Loosen bolt B.

Drive belt tension: New belt: 160 to 180 lbf Used belt: 115 to 135 lbf

ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

HINT:

"New V belt" refers to a belt which has been used for less than 5 minutes on a running engine.
"Used V belt" refers to a belt which has been used for 5 minutes or more on a running engine

ADJUST V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1

(d) Tighten bolt A.

Torque: 58 NVm (591 kgfVcm, 43 ftVlbf) (e) Tighten bolt B.

Torque: 18 NVm (183 kgfVcm, 13 ftVlbf)

Replacement

1. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 (a) Loosen bolt A. (b) Loosen bolt B. (c) Loosen bolt C and remove the V belt. 2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULL ...

Integration control & panel ASSY

COMPONENTS OVERHAUL HINT: COMPONENTS: see page 55-25 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER (SEE PAGE 71-10 ) 2. REMOVE INTEGRATION CONTROL & PANEL ASSY (SEE PAGE 71-10 ...

More about Toyota Highlander:

Voice settings
This screen is used for guidance for voice command systems setting. Adjust the voice guidance volume setting. Set the voice recognition prompts “high”, “low” or “off”. Set the train voice recognition. Set the voice prompt interrupt on/off. Voice recognition tutorial ...