Toyota Highlander Owners Manual: Warning lights
Warning lights inform the driver of malfunctions in the indicated vehicle’s systems.
*1
Brake system
warning
light
*1
Brake system
warning
light
*1,2
Charging
system warning
light
*1,2
Low engine oil
pressure
warning light
*1
Malfunction
indicator
lamp
*1
Malfunction
indicator
lamp
*1
Srs warning
light
*1
Abs warning
light
*1
Abs warning
light
*1
Electric power
steering
system warning light
*1,2,3
Pre-collision
system
warning light
*1
Slip indicator
*2
Open door
warning light
Low fuel level
warning
light
Seat belt reminder
light
*1
Master warning
light
*1
Tire pressure
warning
light
*1: Vehicles without a smart key system: these lights turn on when the engine switch is turned to the “on” position to indicate that a system check is being performed. They will turn off after the engine is started, or after a few seconds. There may be a malfunction in a system if a light does not come on, or if the lights do not turn off. Have the vehicle inspected by your toyota dealer.
Vehicles with a smart key system: these lights turn on when the engine switch is turned to ignition on mode to indicate that a system check is being performed. They will turn off after the engine is started, or after a few seconds. There may be a malfunction in a system if a light does not come on, or if the lights do not turn off. Have the vehicle inspected by your toyota dealer.
*2: If equipped
*3: The light flashes to indicate a malfunction.
Warning lights and
indicators
The warning lights and indicators on the instrument cluster and
center panel inform the driver of the status of the vehicle’s various
systems.
For the purpose of explanation, the following illust ...
Indicators
The indicators inform the driver of the operating state of the vehicle’s
various systems.
Turn signal
indicator
Headlight
indicator
Tail light
indicator
Headlight high
beam
indicator
*2 ...
More about Toyota Highlander:
Stabilizer bar front (FF)
REPLACEMENT
HINT:
COMPONENTS: See page 26-3 .
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT STABILIZER LINK ASSY LH
(a) Remove the 2 nuts and the front stabilizer link assy LH.
HINT:
If ...