Toyota Highlander manuals

Toyota Highlander Service Manual: VVT sensor (3MZ-FE)

REPLACEMENT

HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).

1. REMOVE AIR CLEANER ASSY

2. REMOVE VVT SENSOR

REMOVE VVT SENSOR


(a) Disconnect the sensor connector.

(b) Remove the bolt and sensor.

3. INSTALL VVT SENSOR

(a) Apply a light coat of engine oil to a new O-ring. Install the O-ring onto the sensor.

(b) Install the sensor with the bolt.

Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf) (c) Connect the sensor connector.

4. INSTALL AIR CLEANER ASSY (See page 14-24 )

Inspection
NOTICE: In this section, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 C (14 F) to 50 C (122 F). "Hot" means approximately 50 C (122 F) to 100 C ...

Crankshaft position sensor (3MZ-FE)
REPLACEMENT HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ). 1. REMOVE ENGINE UNDER COVER NO.1 (a) Remove the 6 screws, 2 clips and under cov ...

More about Toyota Highlander:

Rear view monitor system precautions
Area displayed on screen The rear view monitor system displays an image of the view from the bumper of the rear area of the vehicle. To adjust the image on the rear view monitor system screen. The area displayed on the screen may vary according to vehicle orientation conditions. ...

В© 2011-2026 Copyright www.tohighlander.com