Toyota Highlander Service Manual: Vehicle control system
Toyota Highlander Service Manual / Vehicle control system
Ignition switch
PROBLEM SYMPTOMS TABLE
|
Symptom |
Suspected Area |
| Ignition switch is not set in each position |
|
INSPECTION
1. INSPECT IGNITION OR STARTER SWITCH ASSY
(a) Inspect the ignition switch continuity.
If the continuity is not as specified, replace the ignition switch.
Inspection
1. INSPECT GARAGE DOOR OPENER
(a) Press the switch and check that each red LED turns on.
If one or more of the switches does not turn on the LED,
confirm normal operation of the fuse and wire ...
Cruise control
CRUISE CONTROL MAIN SWITCH
REPLACEMENT
HINT:
Installation is in the reverse order of removal.
1. PRECAUTION (SEE PAGE 60-1 )
2. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE PAGE 60-1 )
3. REMOVE ST ...
More about Toyota Highlander:
Overhaul
1. REMOVE GENERATOR PULLEY
SST 09820-63010 (09820-06010, 09820-06020)
HINT:
(a) Hold SST (1-A) with a torque wrench, and tighten SST
(1-B) clockwise to the specified torque.
Torque: 39 NVm (400 kgfVcm, 29 ftVlbf)
NOTICE:
Check that SST is secured to the rotor shaft.
(b) Mount S ...
В© 2011-2021 Copyright www.tohighlander.com