Toyota Highlander Service Manual: Replacement

Toyota Highlander Service Manual / Engine hood/door / Back door stay ASSY LH / Replacement

HINT:

The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring addition information are included.
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ).

1. REMOVE BACK DOOR STAY ASSY LH

REMOVE BACK DOOR STAY ASSY LH

(a) Remove the 4 bolts and back door stay from the back door panel.

HINT: While supporting the back door by hand, remove the back door stay.

2. INSTALL BACK DOOR STAY ASSY LH

(a) Install the back door stay with the 4 bolts.

Torque: 8.0 NVm (82 kgfVcm, 71 in.Vlbf)

Disposal

1. DISPOSE OF BACK DOOR STAY ASSY LH (a) Horizontally fix the stay in a vise with the piston-rod pulled out. (b) Wearing safety glasses, gradually cut a part between A and B (shown in the illu ...

More about Toyota Highlander:

Replacement
1. REMOVE FRONT WHEEL 2. REMOVE ENGINE UNDER COVER NO.1 3. REMOVE FRONT FENDER APRON SEAL RH 4. DRAIN ENGINE OIL (a) Install a new gasket after draining engine oil. Torque: 45 NVm (459 kgfVcm, 33 ftVlbf) 5. REMOVE V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 (See page 14-125 ) 6. R ...