Toyota Highlander Service Manual: Rear combination lamp ASSY LH
OVERHAUL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Installation is in the reverse order of removal.
1. REMOVE REAR COMBINATION LAMP SERVICE COVER LH
2. REMOVE REAR COMBINATION LAMP ASSY LH
(a) Disconnect the connector.
(b) Remove the 2 nuts and the rear combination lamp assy LH.
3. REMOVE REAR COMBINATION LAMP LENS GASKET RH
4. REMOVE REAR COMBINATION LAMP BULB
(a) Remove the rear combination lamp bulb and the socket and wire.
(b) Remove the rear combination lamp bulb from the socket and wire.
5. REMOVE REAR COMBINATION LAMP SOCKET AND WIRE SUB-ASSY LH
6. REMOVE REAR COMBINATION LAMP LENS LH
Adjustment
1. VEHICLE PREPARATION FOR FOGLAMP AIM ADJUSTMENT
(a) Prepare the vehicle:
Ensure there is no damage or deformation to the body around the
headlamps.
Fill the fuel tank.
Make sure that the ...
License plate lamp ASSY
REPLACEMENT
HINT:
Installation is in the reverse order of removal.
1. REMOVE ASSIST STRAP HOLE COVER (SEE PAGE 75-20 )
2. REMOVE ASSIST STRAP ASSY RH (SEE PAGE 75-20 )
3. REMOVE BACK DOOR TRIM PA ...
More about Toyota Highlander:
On-vehicle inspection
1. CHECK THROTTLE BODY
(a) Listen to the throttle control motor operating sounds.
Turn the ignition switch ON.
When pressing the accelerator pedal position sensor lever, listen
to the running motor. Make sure
no friction noise comes from the motor.
If friction noise exists ...
