Toyota Highlander Service Manual: Ignition system (3MZ-FE)

Crankshaft position sensor (2AZ-FE)

REPLACEMENT HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ). 1. REMOVE ENGINE UNDER COVER NO.1 (a) Remove the 6 screws, 2 clips and under cov ...

On-vehicle inspection

NOTICE: In this section, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 C (14 F) to 50 C (122 F). "Hot" means approximately 50 C (122 F) to 100 C ...

More about Toyota Highlander:

On-vehicle inspection
1. INSPECT COOLER CONDENSER ASSY (a) If a fin of the cooler condenser assy is dirty, clean it with water and dry it with compressor air. NOTICE: Do not damage the fin of the condenser assy. (b) If a fin of the condenser assy is bent, make it straight using a screwdriver or pliers. 2. INSPEC ...